NE2K-DIAG(8)                                         NE2K-DIAG(8)



NAME
       ne2k-diag  - Diagnostic program for NE2000 ethernet cards.

SYNOPSIS
       ne2k-diag [options]

DESCRIPTION
       ne2k-diag is used to diagnose detection ("probe") problems
       with NE1000 and NE2000 work-alike cards. The probe routine
       is very similar to that used in the Linux  NE2000  driver,
       and should work with any NE2000 clone.

OPTIONS
       These  programs  follow the usual GNU command line syntax,
       with long options starting with two dashes (`-').  A  sum-
       mary of options is included below.

       -h, --help
              Show summary of options.

       -V, --version
              Show version of program.

       -v, --verbose
              Verbose mode.

       -D     Debug mode.

       -a, --show-registers
              show chip status (use -aa for even more)

       -e, --show-eeprom
              Dump  EEPROM  contents to stdout. (use -ee for even
              more)

       -F, -X, --interface
              Valid values are 0-3.

       -p, --base-address <port>
              Specify port to use.

       -P, --new-address <address>
              Set card to a new hardware address.

       -Q, --new-irq <irq>
              Set card to a new irq. Valid values are 2-5,7,9-15

       -w     Really write to EEPROM.

SEE ALSO
       mii-diag(8)

AUTHOR
       This  manual  page  was   written   by   Alain   Schroeder
       <alain@debian.org>,  for  the Debian GNU/Linux system (but
       may be used by others).



                          March 8, 2001              NE2K-DIAG(8)