ATLANTIC-SETUP(8) ATLANTIC-SETUP(8) NAME atlantic-setup - Setup program for ethernet cards based on AT/LANTIC DP83905 chips. SYNOPSIS atlantic-setup [options] DESCRIPTION atlantic-setup is a setup and diagnostic program for ISA NE2000 Ethernet adapters. It has specific support for con- figuring the National Semiconductor AT/LANTIC DP83905 used in on ISA Ethernet adapters such as the NE2000plus. It also works several work-alike chips from other vendors. OPTIONS These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A sum- mary of options is included below. -h, --help Show summary of options. -V, --version Show version of program. -v, --verbose Verbose mode. -q, --quiet Be very unverbose. -a, --all Print all registers. -N, --NE2000 Set card to NE2000 mode. -W, --wd8013 Set card to WD8013 mode. -p, --base-address Specify port to use. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300). -P, --new_ioport Set card to use new port. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300). -F, --interface Interface number. Valid Options are: 10baseT, 10base2, 10base5, AUI. -Q, -i, --irq Specify new interrupt. Valid values are: 3-5,9-12,15. -w, --write-EEPROM Write to the EEPROMS with the specified values. SEE ALSO mii-diag(8) AUTHOR This manual page was written by Alain Schroeder , for the Debian GNU/Linux system (but may be used by others). March 8, 2001 ATLANTIC-SETUP(8)