AL1700-DIAG(8)                                     AL1700-DIAG(8)



NAME
       al1700-diag  -  Diagnostic  program for the Allied Telesis
       AT1700

SYNOPSIS
       al1700-diag [options]

DESCRIPTION
       al1700-diag is a diagnostic program for the Allied Telesis
       AT1700,  and  similar  boards  built  around  the  Fujitsu
       MB86965.  It does not test every possible hardware  fault,
       but it does verify the basic functionality ofthe board.

OPTIONS
       These  programs  follow the usual GNU command line syntax,
       with long options starting with two dashes (`-').  A  sum-
       mary of options is included below.

       -h, --help
              Show summary of options.

       -V, --version
              Show version of program.

       -v, --verbose
              Verbose mode.

       -q, --quiet
              Be very unverbose.

       -a, --all
              Print all registers.

       -e, --show-eeprom
              Dump EEPROM contents to stdout.

       -p, --base-address <port>
              Specify port to use.

       -F, --new-interface <interface>
              Interface  number.  Options  that  make  sense are:
              10baseT,  100baseTx,  10baseT-FDX,   100baseTx-FDX,
              100baseT4,   100baseFx,   100baseFx-FDX,   MII  and
              Autosense.

       -P <address>
              Set card to a new IO base address.

       -Q <irq>
              Set card to a new IRQ.

       -m, --show-mii
              Dump MII management registers.

       -r, --reset-ASIC
              Reset the ASIC.

       -m     Tests multicast.

       -w, --write-EEPROM <values>
              Write to the EEPROMS with the specified values.  Do
              not use this, if you do not know what you do!

SEE ALSO
       mii-diag(8)

AUTHOR
       This   manual   page   was   written  by  Alain  Schroeder
       <alain@debian.org>, for the Debian GNU/Linux  system  (but
       may be used by others).



                        February 23, 2001          AL1700-DIAG(8)