3C5X9SETUP(8)                                       3C5X9SETUP(8)



NAME
       3c5x9setup - setup program for the 3Com 3x9 cards.

SYNOPSIS
       3c5x9setup [options]

DESCRIPTION
       3c5x9setup  is  a  program  that you can use to setup 3Com
       3c5x9 series ethercards.

OPTIONS
       These programs follow the usual GNU command  line  syntax,
       with  long options starting with two dashes (`-').  A sum-
       mary of options is included below.

       -h, --help
              Show summary of options.

       -v, --version
              Show version of program.

       -V, --verbose
              Verbose mode

       -D, --debug
              Show Debug messages

       -a, --all
              Print all registers

       -p, --base-address <port>
              Specify port to use

       -E, --emergency-rewrite
              Re-write a corrupted EEPROM

       -f, --force-detection
              Force if card is busy

       -F, --new-interface <type>
              Interface type to be used.  This  can  be  10baseT,
              10base2 or AUI.

       -P, --new-IOaddress, --new-base-address <port>
              New base I/O address

       -H, --new-hwaddress <addr>
              New base hardware address

       -Q, --new-irq <irq>
              Specify interrupt number

       -w, --write-EEPROM <values>
              Write to the EEPROMS with the specified values.

SEE ALSO
       el3diag(8),

AUTHOR
       This   manual   page   was   written  by  Alain  Schroeder
       <alain@debian.org>, for the Debian GNU/Linux  system  (but
       may be used by others).